From: Gabor Juhos Date: Sun, 2 Mar 2014 19:54:42 +0000 (+0100) Subject: spi: spi-ath79: fix initial GPIO CS line setup X-Git-Url: http://pileus.org/git/?a=commitdiff_plain;h=61d1cf163c8653934cc8cd5d0b2a562d0990c265;p=~andy%2Flinux spi: spi-ath79: fix initial GPIO CS line setup The 'ath79_spi_setup_cs' function initializes the chip select line of a given SPI device in order to make sure that the device is inactive. If the SPI_CS_HIGH bit is set for a given device, it means that the CS line of that device is active HIGH so it must be set to LOW initially. In case of GPIO CS lines, the 'ath79_spi_setup_cs' function does the opposite of that due to the wrong GPIO flags. Fix the code to use the correct GPIO flags. Reported-by: Ronald Wahl Signed-off-by: Gabor Juhos Signed-off-by: Mark Brown Cc: stable@vger.kernel.org --- diff --git a/drivers/spi/spi-ath79.c b/drivers/spi/spi-ath79.c index 31534b51715..c3b2fb9b671 100644 --- a/drivers/spi/spi-ath79.c +++ b/drivers/spi/spi-ath79.c @@ -132,9 +132,9 @@ static int ath79_spi_setup_cs(struct spi_device *spi) flags = GPIOF_DIR_OUT; if (spi->mode & SPI_CS_HIGH) - flags |= GPIOF_INIT_HIGH; - else flags |= GPIOF_INIT_LOW; + else + flags |= GPIOF_INIT_HIGH; status = gpio_request_one(cdata->gpio, flags, dev_name(&spi->dev));