Previously, git-svn would blindly append '*' even if it was specified by
the user during initialization (for certain SVN setups, it is
necessary).
Now, the following command will work correctly:
git svn init -T trunk/docutils \
-t 'tags/*/docutils' \
-b 'branches/*/docutils' \
svn://svn.berlios.de/docutils
Thanks to martin f krafft for the bug report:
> My git-svn target configuration is
>
> [svn-remote "svn"]
> url = svn://svn.berlios.de/docutils
> fetch = trunk/docutils:refs/remotes/trunk
> branches = branches/*/docutils:refs/remotes/*
> tags = tags/*/docutils:refs/remotes/tags/*
>
> Unfortunately, when I run
>
> git-svn init -T trunk/docutils -t 'tags/*/docutils'
> -b 'branches/*/docutils'
>
> then I get (note the two asterisks on the left hand side):
>
> branches = branches/*/docutils/*:refs/remotes/*
> tags = tags/*/docutils/*:refs/remotes/tags/*
>
> I took a brief stab at the code but I can't even figure out where
> the /* is appended, so I defer to you.
>
> It should be trivial to keep git-svn from appending /* if the left
> side already contains an asterisk.
Signed-off-by: Eric Wong <normalperson@yhbt.net>
Tested-by: martin f krafft <madduck@madduck.net>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
"wanted to set to: $gs->{url}\n";
}
command_oneline('config', $k, $gs->{url}) unless $orig_url;
- my $remote_path = "$ra->{svn_path}/$repo_path/*";
+ my $remote_path = "$ra->{svn_path}/$repo_path";
$remote_path =~ s#/+#/#g;
$remote_path =~ s#^/##g;
+ $remote_path .= "/*" if $remote_path !~ /\*/;
my ($n) = ($switch =~ /^--(\w+)/);
if (length $pfx && $pfx !~ m#/$#) {
die "--prefix='$pfx' must have a trailing slash '/'\n";