mfd: Enable register cache for wm8994 devices

As part of this we provide information about the registers that exist in
the device to the regmap core, drop the small amount of cache that the
core had been using and let regmap do the sync.

Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: Samuel Ortiz <sameo@linux.intel.com>

diff --git a/drivers/mfd/wm8994-core.c b/drivers/mfd/wm8994-core.c
index 016769475ffb559f38c0e286b7dca623b329822a..aafac5b5f3a54bfa47193d36a72740663c0388ef 100644 (file)
--- a/drivers/mfd/wm8994-core.c
+++ b/drivers/mfd/wm8994-core.c
@@ -28,11 +28,7 @@
 #include <linux/mfd/wm8994/pdata.h>
 #include <linux/mfd/wm8994/registers.h>
 
-static int wm8994_read(struct wm8994 *wm8994, unsigned short reg,
-                      int bytes, void *dest)
-{
-       return regmap_raw_read(wm8994->regmap, reg, dest, bytes);
-}
+#include "wm8994.h"
 
 /**
  * wm8994_reg_read: Read a single WM8994 register.
@@ -68,12 +64,6 @@ int wm8994_bulk_read(struct wm8994 *wm8994, unsigned short reg,
        return regmap_bulk_read(wm8994->regmap, reg, buf, count);
 }
 
-static int wm8994_write(struct wm8994 *wm8994, unsigned short reg,
-                       int bytes, const void *src)
-{
-       return regmap_raw_write(wm8994->regmap, reg, src, bytes);
-}
-
 /**
  * wm8994_reg_write: Write a single WM8994 register.
  *
@@ -258,27 +248,14 @@ static int wm8994_suspend(struct device *dev)
                                WM8994_LDO1ENA_PD | WM8994_LDO2ENA_PD,
                                WM8994_LDO1ENA_PD | WM8994_LDO2ENA_PD);
 
-       /* GPIO configuration state is saved here since we may be configuring
-        * the GPIO alternate functions even if we're not using the gpiolib
-        * driver for them.
-        */
-       ret = wm8994_read(wm8994, WM8994_GPIO_1, WM8994_NUM_GPIO_REGS * 2,
-                         &wm8994->gpio_regs);
-       if (ret < 0)
-               dev_err(dev, "Failed to save GPIO registers: %d\n", ret);
-
-       /* For similar reasons we also stash the regulator states */
-       ret = wm8994_read(wm8994, WM8994_LDO_1, WM8994_NUM_LDO_REGS * 2,
-                         &wm8994->ldo_regs);
-       if (ret < 0)
-               dev_err(dev, "Failed to save LDO registers: %d\n", ret);
-
        /* Explicitly put the device into reset in case regulators
         * don't get disabled in order to ensure consistent restart.
         */
        wm8994_reg_write(wm8994, WM8994_SOFTWARE_RESET,
                         wm8994_reg_read(wm8994, WM8994_SOFTWARE_RESET));
 
+       regcache_mark_dirty(wm8994->regmap);
+
        wm8994->suspended = true;
 
        ret = regulator_bulk_disable(wm8994->num_supplies,
@@ -294,7 +271,7 @@ static int wm8994_suspend(struct device *dev)
 static int wm8994_resume(struct device *dev)
 {
        struct wm8994 *wm8994 = dev_get_drvdata(dev);
-       int ret, i;
+       int ret;
 
        /* We may have lied to the PM core about suspending */
        if (!wm8994->suspended)
@@ -307,27 +284,12 @@ static int wm8994_resume(struct device *dev)
                return ret;
        }
 
-       /* Write register at a time as we use the cache on the CPU so store
-        * it in native endian.
-        */
-       for (i = 0; i < ARRAY_SIZE(wm8994->irq_masks_cur); i++) {
-               ret = wm8994_reg_write(wm8994, WM8994_INTERRUPT_STATUS_1_MASK
-                                      + i, wm8994->irq_masks_cur[i]);
-               if (ret < 0)
-                       dev_err(dev, "Failed to restore interrupt masks: %d\n",
-                               ret);
+       ret = regcache_sync(wm8994->regmap);
+       if (ret != 0) {
+               dev_err(dev, "Failed to restore register map: %d\n", ret);
+               goto err_enable;
        }
 
-       ret = wm8994_write(wm8994, WM8994_LDO_1, WM8994_NUM_LDO_REGS * 2,
-                          &wm8994->ldo_regs);
-       if (ret < 0)
-               dev_err(dev, "Failed to restore LDO registers: %d\n", ret);
-
-       ret = wm8994_write(wm8994, WM8994_GPIO_1, WM8994_NUM_GPIO_REGS * 2,
-                          &wm8994->gpio_regs);
-       if (ret < 0)
-               dev_err(dev, "Failed to restore GPIO registers: %d\n", ret);
-
        /* Disable LDO pulldowns while the device is active */
        wm8994_set_bits(wm8994, WM8994_PULL_CONTROL_2,
                        WM8994_LDO1ENA_PD | WM8994_LDO2ENA_PD,
@@ -336,6 +298,11 @@ static int wm8994_resume(struct device *dev)
        wm8994->suspended = false;
 
        return 0;
+
+err_enable:
+       regulator_bulk_disable(wm8994->num_supplies, wm8994->supplies);
+
+       return ret;
 }
 #endif
 
@@ -361,11 +328,6 @@ static int wm8994_ldo_in_use(struct wm8994_pdata *pdata, int ldo)
 }
 #endif
 
-static struct regmap_config wm8994_regmap_config = {
-       .reg_bits = 16,
-       .val_bits = 16,
-};
-
 /*
  * Instantiate the generic non-control parts of the device.
  */
@@ -594,6 +556,7 @@ static int wm8994_i2c_probe(struct i2c_client *i2c,
                            const struct i2c_device_id *id)
 {
        struct wm8994 *wm8994;
+       struct regmap_config *regmap_config;
        int ret;
 
        wm8994 = devm_kzalloc(&i2c->dev, sizeof(struct wm8994), GFP_KERNEL);
@@ -605,7 +568,22 @@ static int wm8994_i2c_probe(struct i2c_client *i2c,
        wm8994->irq = i2c->irq;
        wm8994->type = id->driver_data;
 
-       wm8994->regmap = regmap_init_i2c(i2c, &wm8994_regmap_config);
+       switch (wm8994->type) {
+       case WM1811:
+               regmap_config = &wm1811_regmap_config;
+               break;
+       case WM8994:
+               regmap_config = &wm8994_regmap_config;
+               break;
+       case WM8958:
+               regmap_config = &wm8958_regmap_config;
+               break;
+       default:
+               dev_err(wm8994->dev, "Unknown device type %d\n", wm8994->type);
+               return -EINVAL;
+       }
+
+       wm8994->regmap = regmap_init_i2c(i2c, regmap_config);
        if (IS_ERR(wm8994->regmap)) {
                ret = PTR_ERR(wm8994->regmap);
                dev_err(wm8994->dev, "Failed to allocate register map: %d\n",

diff --git a/include/linux/mfd/wm8994/core.h b/include/linux/mfd/wm8994/core.h
index f44bdb7273bd819b5c30b4dba7d808a4ad46e015..d98593d52e7c5ec50aac1affa60eabc83ac2814a 100644 (file)
--- a/include/linux/mfd/wm8994/core.h
+++ b/include/linux/mfd/wm8994/core.h
@@ -70,8 +70,6 @@ struct wm8994 {
 
        /* Used over suspend/resume */
        bool suspended;
-       u16 ldo_regs[WM8994_NUM_LDO_REGS];
-       u16 gpio_regs[WM8994_NUM_GPIO_REGS];
 
        struct regulator_dev *dbvdd;
        int num_supplies;