serial: bfin-uart: Remove ASYNC_CTS_FLOW flag for hardware automatic CTS.

Blackfin uart supports automatic CTS trigger when hardware flow control is enabled.
No need to start and top tx in CTS interrupt. So, remote ASYNC_CTS_FLOW flag.

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

diff --git a/drivers/tty/serial/bfin_uart.c b/drivers/tty/serial/bfin_uart.c
index dedd9ab06d82669ed5f2a58a1f7125f115630c7e..26953bfa6922f4ffbebc8da4bb7a2ac60f672695 100644 (file)
--- a/drivers/tty/serial/bfin_uart.c
+++ b/drivers/tty/serial/bfin_uart.c
@@ -116,11 +116,20 @@ static void bfin_serial_set_mctrl(struct uart_port *port, unsigned int mctrl)
 static irqreturn_t bfin_serial_mctrl_cts_int(int irq, void *dev_id)
 {
        struct bfin_serial_port *uart = dev_id;
-       unsigned int status;
-
-       status = bfin_serial_get_mctrl(&uart->port);
+       unsigned int status = bfin_serial_get_mctrl(&uart->port);
 #ifdef CONFIG_SERIAL_BFIN_HARD_CTSRTS
+       struct tty_struct *tty = uart->port.state->port.tty;
+
        UART_CLEAR_SCTS(uart);
+       if (tty->hw_stopped) {
+               if (status) {
+                       tty->hw_stopped = 0;
+                       uart_write_wakeup(&uart->port);
+               }
+       } else {
+               if (!status)
+                       tty->hw_stopped = 1;
+       }
 #endif
        uart_handle_cts_change(&uart->port, status & TIOCM_CTS);
 
@@ -1358,7 +1367,9 @@ static int bfin_serial_probe(struct platform_device *pdev)
                        uart->cts_pin = -1;
                else {
                        uart->cts_pin = res->start;
+#ifdef CONFIG_SERIAL_BFIN_CTSRTS
                        uart->port.flags |= ASYNC_CTS_FLOW;
+#endif
                }
 
                res = platform_get_resource(pdev, IORESOURCE_IO, 1);