i2c-stu300: Use struct dev_pm_ops for power management

Make the ST-Ericsson U300 I2C controller driver define its PM
callbacks through a struct dev_pm_ops object rather than by using
legacy PM hooks in struct platform_driver.

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>

diff --git a/drivers/i2c/busses/i2c-stu300.c b/drivers/i2c/busses/i2c-stu300.c
index 79b785150c15fd0854cde0bc177a63175fe6f4a1..80dd1c074a08e0d9a7721fdb94de184dbfc9a22a 100644 (file)
--- a/drivers/i2c/busses/i2c-stu300.c
+++ b/drivers/i2c/busses/i2c-stu300.c
@@ -979,31 +979,33 @@ stu300_probe(struct platform_device *pdev)
 }
 
 #ifdef CONFIG_PM
-static int stu300_suspend(struct platform_device *pdev, pm_message_t state)
+static int stu300_suspend(struct device *device)
 {
-       struct stu300_dev *dev = platform_get_drvdata(pdev);
+       struct stu300_dev *dev = dev_get_drvdata(device);
 
        /* Turn off everything */
        stu300_wr8(0x00, dev->virtbase + I2C_CR);
        return 0;
 }
 
-static int stu300_resume(struct platform_device *pdev)
+static int stu300_resume(struct device *device)
 {
        int ret = 0;
-       struct stu300_dev *dev = platform_get_drvdata(pdev);
+       struct stu300_dev *dev = dev_get_drvdata(device);
 
        clk_enable(dev->clk);
        ret = stu300_init_hw(dev);
        clk_disable(dev->clk);
 
        if (ret != 0)
-               dev_err(&pdev->dev, "error re-initializing hardware.\n");
+               dev_err(device, "error re-initializing hardware.\n");
        return ret;
 }
+
+static SIMPLE_DEV_PM_OPS(stu300_pm, stu300_suspend, stu300_resume);
+#define STU300_I2C_PM  (&stu300_pm)
 #else
-#define stu300_suspend NULL
-#define stu300_resume NULL
+#define STU300_I2C_PM  NULL
 #endif
 
 static int __exit
@@ -1028,10 +1030,9 @@ static struct platform_driver stu300_i2c_driver = {
        .driver = {
                .name   = NAME,
                .owner  = THIS_MODULE,
+               .pm     = STU300_I2C_PM,
        },
        .remove         = __exit_p(stu300_remove),
-       .suspend        = stu300_suspend,
-       .resume         = stu300_resume,
 
 };