struct stmmac_priv *priv = netdev_priv(dev);
int ret;
+ stmmac_clk_enable(priv);
+
stmmac_check_ether_addr(priv);
/* MDIO bus Registration */
if (ret < 0) {
pr_debug("%s: MDIO bus (id: %d) registration failed",
__func__, priv->plat->bus_id);
- return ret;
+ goto open_clk_dis;
}
#ifdef CONFIG_STMMAC_TIMER
priv->tm = kzalloc(sizeof(struct stmmac_timer *), GFP_KERNEL);
- if (unlikely(priv->tm == NULL))
- return -ENOMEM;
+ if (unlikely(priv->tm == NULL)) {
+ ret = -ENOMEM;
+ goto open_clk_dis;
+ }
priv->tm->freq = tmrate;
init_dma_desc_rings(dev);
/* DMA initialization and SW reset */
- ret = priv->hw->dma->init(priv->ioaddr, priv->plat->pbl,
+ ret = priv->hw->dma->init(priv->ioaddr, priv->plat->dma_cfg->pbl,
+ priv->plat->dma_cfg->fixed_burst,
+ priv->plat->dma_cfg->burst_len,
priv->dma_tx_phy, priv->dma_rx_phy);
if (ret < 0) {
pr_err("%s: DMA initialization failed\n", __func__);
if (priv->phydev)
phy_disconnect(priv->phydev);
+open_clk_dis:
+ stmmac_clk_disable(priv);
return ret;
}
stmmac_exit_fs();
#endif
stmmac_mdio_unregister(dev);
+ stmmac_clk_disable(priv);
return 0;
}
goto error;
}
+ if (stmmac_clk_get(priv))
+ goto error;
+
return priv;
error:
/* Enable Power down mode by programming the PMT regs */
if (device_may_wakeup(priv->device))
priv->hw->mac->pmt(priv->ioaddr, priv->wolopts);
- else
+ else {
stmmac_set_mac(priv->ioaddr, false);
-
+ /* Disable clock in case of PWM is off */
+ stmmac_clk_disable(priv);
+ }
spin_unlock(&priv->lock);
return 0;
}
* from another devices (e.g. serial console). */
if (device_may_wakeup(priv->device))
priv->hw->mac->pmt(priv->ioaddr, 0);
+ else
+ /* enable the clk prevously disabled */
+ stmmac_clk_enable(priv);
netif_device_attach(ndev);