#include "e1000.h"
/* Change Log
+ * 7.0.33 3-Feb-2006
+ * o Added another fix for the pass false carrier bit
+ * 7.0.32 24-Jan-2006
+ * o Need to rebuild with noew version number for the pass false carrier
+ * fix in e1000_hw.c
+ * 7.0.30 18-Jan-2006
+ * o fixup for tso workaround to disable it for pci-x
+ * o fix mem leak on 82542
+ * o fixes for 10 Mb/s connections and incorrect stats
+ * 7.0.28 01/06/2006
+ * o hardware workaround to only set "speed mode" bit for 1G link.
+ * 7.0.26 12/23/2005
+ * o wake on lan support modified for device ID 10B5
+ * o fix dhcp + vlan issue not making it to the iAMT firmware
+ * 7.0.24 12/9/2005
+ * o New hardware support for the Gigabit NIC embedded in the south bridge
+ * o Fixes to the recycling logic (skb->tail) from IBM LTC
* 6.3.9 12/16/2005
* o incorporate fix for recycled skbs from IBM LTC
* 6.3.7 11/18/2005
* rx_buffer_len
* 6.3.1 9/19/05
* o Use adapter->tx_timeout_factor in Tx Hung Detect logic
- (e1000_clean_tx_irq)
+ * (e1000_clean_tx_irq)
* o Support for 8086:10B5 device (Quad Port)
- * 6.2.14 9/15/05
- * o In AMT enabled configurations, set/reset DRV_LOAD bit on interface
- * open/close
- * 6.2.13 9/14/05
- * o Invoke e1000_check_mng_mode only for 8257x controllers since it
- * accesses the FWSM that is not supported in other controllers
- * 6.2.12 9/9/05
- * o Add support for device id E1000_DEV_ID_82546GB_QUAD_COPPER
- * o set RCTL:SECRC only for controllers newer than 82543.
- * o When the n/w interface comes down reset DRV_LOAD bit to notify f/w.
- * This code was moved from e1000_remove to e1000_close
- * 6.2.10 9/6/05
- * o Fix error in updating RDT in el1000_alloc_rx_buffers[_ps] -- one off.
- * o Enable fc by default on 82573 controllers (do not read eeprom)
- * o Fix rx_errors statistic not to include missed_packet_count
- * o Fix rx_dropped statistic not to include missed_packet_count
- (Padraig Brady)
- * 6.2.9 8/30/05
- * o Remove call to update statistics from the controller ib e1000_get_stats
- * 6.2.8 8/30/05
- * o Improved algorithm for rx buffer allocation/rdt update
- * o Flow control watermarks relative to rx PBA size
- * o Simplified 'Tx Hung' detect logic
- * 6.2.7 8/17/05
- * o Report rx buffer allocation failures and tx timeout counts in stats
- * 6.2.6 8/16/05
- * o Implement workaround for controller erratum -- linear non-tso packet
- * following a TSO gets written back prematurely
- * 6.2.5 8/15/05
- * o Set netdev->tx_queue_len based on link speed/duplex settings.
- * o Fix net_stats.rx_fifo_errors <p@draigBrady.com>
- * o Do not power off PHY if SoL/IDER session is active
- * 6.2.4 8/10/05
- * o Fix loopback test setup/cleanup for 82571/3 controllers
- * o Fix parsing of outgoing packets (e1000_transfer_dhcp_info) to treat
- * all packets as raw
- * o Prevent operations that will cause the PHY to be reset if SoL/IDER
- * sessions are active and log a message
- * 6.2.2 7/21/05
- * o used fixed size descriptors for all MTU sizes, reduces memory load
- * 6.1.2 4/13/05
- * o Fixed ethtool diagnostics
- * o Enabled flow control to take default eeprom settings
- * o Added stats_lock around e1000_read_phy_reg commands to avoid concurrent
- * calls, one from mii_ioctl and other from within update_stats while
- * processing MIIREG ioctl.
*/
char e1000_driver_name[] = "e1000";
void e1000_free_all_tx_resources(struct e1000_adapter *adapter);
void e1000_free_all_rx_resources(struct e1000_adapter *adapter);
static int e1000_setup_tx_resources(struct e1000_adapter *adapter,
- struct e1000_tx_ring *txdr);
+ struct e1000_tx_ring *txdr);
static int e1000_setup_rx_resources(struct e1000_adapter *adapter,
- struct e1000_rx_ring *rxdr);
+ struct e1000_rx_ring *rxdr);
static void e1000_free_tx_resources(struct e1000_adapter *adapter,
- struct e1000_tx_ring *tx_ring);
+ struct e1000_tx_ring *tx_ring);
static void e1000_free_rx_resources(struct e1000_adapter *adapter,
- struct e1000_rx_ring *rx_ring);
+ struct e1000_rx_ring *rx_ring);
void e1000_update_stats(struct e1000_adapter *adapter);
/* Local Function Prototypes */
uint32_t rdlen, rctl, rxcsum, ctrl_ext;
if (adapter->rx_ps_pages) {
+ /* this is a 32 byte descriptor */
rdlen = adapter->rx_ring[0].count *
sizeof(union e1000_rx_desc_packet_split);
adapter->clean_rx = e1000_clean_rx_irq_ps;
/* Workaround for Controller erratum --
* descriptor for non-tso packet in a linear SKB that follows a
* tso gets written back prematurely before the data is fully
- * DMAd to the controller */
+ * DMA'd to the controller */
if (!skb->data_len && tx_ring->last_tx_tso &&
- !skb_shinfo(skb)->tso_size) {
+ !skb_shinfo(skb)->tso_size) {
tx_ring->last_tx_tso = 0;
size -= 4;
}
printk(KERN_ERR
"__pskb_pull_tail failed.\n");
dev_kfree_skb_any(skb);
- return -EFAULT;
+ return NETDEV_TX_OK;
}
len = skb->len - skb->data_len;
break;
#ifdef NETIF_F_TSO
/* Controller Erratum workaround */
if (!skb->data_len && tx_ring->last_tx_tso &&
- !skb_shinfo(skb)->tso_size)
+ !skb_shinfo(skb)->tso_size)
count++;
#endif
if (adapter->pcix_82544)
count += nr_frags;
- if (adapter->hw.tx_pkt_filtering && (adapter->hw.mac_type == e1000_82573) )
+
+ if (adapter->hw.tx_pkt_filtering &&
+ (adapter->hw.mac_type == e1000_82573))
e1000_transfer_dhcp_info(adapter, skb);
local_irq_save(flags);
goto map_skb;
}
-
if (unlikely(!skb)) {
/* Better luck next round */
adapter->alloc_rx_buff_failed++;
spin_unlock_irqrestore(&adapter->stats_lock, flags);
return -EIO;
}
- if (adapter->hw.phy_type == e1000_phy_m88) {
+ if (adapter->hw.phy_type == e1000_media_type_copper) {
switch (data->reg_num) {
case PHY_CTRL:
if (mii_reg & MII_CR_POWER_DOWN)
else
spddplx = SPEED_10;
spddplx += (mii_reg & 0x100)
- ? FULL_DUPLEX :
- HALF_DUPLEX;
+ ? DUPLEX_FULL :
+ DUPLEX_HALF;
retval = e1000_set_spd_dplx(adapter,
spddplx);
if (retval) {
}
#ifdef CONFIG_PM
-/* these functions save and restore 16 or 64 dwords (64-256 bytes) of config
- * space versus the 64 bytes that pci_[save|restore]_state handle
+/* Save/restore 16 or 64 dwords of PCI config space depending on which
+ * bus we're on (PCI(X) vs. PCI-E)
*/
#define PCIE_CONFIG_SPACE_LEN 256
#define PCI_CONFIG_SPACE_LEN 64
struct pci_dev *dev = adapter->pdev;
int size;
int i;
+
if (adapter->hw.mac_type >= e1000_82571)
size = PCIE_CONFIG_SPACE_LEN;
else
struct pci_dev *dev = adapter->pdev;
int size;
int i;
+
if (adapter->config_space == NULL)
return;
+
if (adapter->hw.mac_type >= e1000_82571)
size = PCIE_CONFIG_SPACE_LEN;
else
e1000_down(adapter);
#ifdef CONFIG_PM
- /* implement our own version of pci_save_state(pdev) because pci
- * express adapters have larger 256 byte config spaces */
+ /* Implement our own version of pci_save_state(pdev) because pci-
+ * express adapters have 256-byte config spaces. */
retval = e1000_pci_save_state(adapter);
if (retval)
return retval;
retval = pci_enable_wake(pdev, PCI_D3hot, 0);
if (retval)
DPRINTK(PROBE, ERR, "Error enabling D3 wake\n");
- retval = pci_enable_wake(pdev, PCI_D3cold, 0); /* 4 == D3 cold */
+ retval = pci_enable_wake(pdev, PCI_D3cold, 0);
if (retval)
DPRINTK(PROBE, ERR, "Error enabling D3 cold wake\n");
}
DPRINTK(PROBE, ERR, "Error enabling D3 wake\n");
retval = pci_enable_wake(pdev, PCI_D3cold, 1);
if (retval)
- DPRINTK(PROBE, ERR, "Error enabling D3 cold wake\n");
+ DPRINTK(PROBE, ERR,
+ "Error enabling D3 cold wake\n");
}
}
projects / ~andy / linux / blobdiff