* complete immediately.
*/
-/* These addresses are only used if yamon doesn't tell us what
- * the mac address is, and the mac address is not passed on the
- * command line.
- */
-static unsigned char au1000_mac_addr[6] __devinitdata = {
- 0x00, 0x50, 0xc2, 0x0c, 0x30, 0x00
-};
-
struct au1000_private *au_macs[NUM_ETH_INTERFACES];
/*
if (!aup->phy_dev)
return -EINVAL; /* PHY not controllable */
- return phy_mii_ioctl(aup->phy_dev, if_mii(rq), cmd);
+ return phy_mii_ioctl(aup->phy_dev, rq, cmd);
}
static const struct net_device_ops au1000_netdev_ops = {
db_dest_t *pDB, *pDBfree;
int irq, i, err = 0;
struct resource *base, *macen;
- char ethaddr[6];
base = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!base) {
}
aup->mac_id = pdev->id;
- if (pdev->id == 0) {
- if (prom_get_ethernet_addr(ethaddr) == 0)
- memcpy(au1000_mac_addr, ethaddr, sizeof(au1000_mac_addr));
- else {
- netdev_info(dev, "No MAC address found\n");
- /* Use the hard coded MAC addresses */
- }
-
+ if (pdev->id == 0)
au1000_setup_hw_rings(aup, MAC0_RX_DMA_ADDR, MAC0_TX_DMA_ADDR);
- } else if (pdev->id == 1)
+ else if (pdev->id == 1)
au1000_setup_hw_rings(aup, MAC1_RX_DMA_ADDR, MAC1_TX_DMA_ADDR);
- /*
- * Assign to the Ethernet ports two consecutive MAC addresses
- * to match those that are printed on their stickers
- */
- memcpy(dev->dev_addr, au1000_mac_addr, sizeof(au1000_mac_addr));
- dev->dev_addr[5] += pdev->id;
+ /* set a random MAC now in case platform_data doesn't provide one */
+ random_ether_addr(dev->dev_addr);
*aup->enable = 0;
aup->mac_enabled = 0;
dev_info(&pdev->dev, "no platform_data passed, PHY search on MAC0\n");
aup->phy1_search_mac0 = 1;
} else {
+ if (is_valid_ether_addr(pd->mac))
+ memcpy(dev->dev_addr, pd->mac, 6);
+
aup->phy_static_config = pd->phy_static_config;
aup->phy_search_highest_addr = pd->phy_search_highest_addr;
aup->phy1_search_mac0 = pd->phy1_search_mac0;