return ret;
}
-static int sdio_read_cccr(struct mmc_card *card)
+static int sdio_read_cccr(struct mmc_card *card, u32 ocr)
{
int ret;
int cccr_vsn;
+ int uhs = ocr & R4_18V_PRESENT;
unsigned char data;
unsigned char speed;
card->scr.sda_spec3 = 0;
card->sw_caps.sd3_bus_mode = 0;
card->sw_caps.sd3_drv_type = 0;
- if (cccr_vsn >= SDIO_CCCR_REV_3_00) {
+ if (cccr_vsn >= SDIO_CCCR_REV_3_00 && uhs) {
card->scr.sda_spec3 = 1;
ret = mmc_io_rw_direct(card, 0, 0,
SDIO_CCCR_UHS, 0, &data);
* Inform the card of the voltage
*/
if (!powered_resume) {
+ /* The initialization should be done at 3.3 V I/O voltage. */
+ mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330, 0);
+
err = mmc_send_io_op_cond(host, host->ocr, &ocr);
if (err)
goto err;
/*
* Read the common registers.
*/
- err = sdio_read_cccr(card);
+ err = sdio_read_cccr(card, ocr);
if (err)
goto remove;
* With these steps taken, mmc_select_voltage() is also required to
* restore the correct voltage setting of the card.
*/
+
+ /* The initialization should be done at 3.3 V I/O voltage. */
+ if (!mmc_card_keep_power(host))
+ mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330, 0);
+
sdio_reset(host);
mmc_go_idle(host);
mmc_send_if_cond(host, host->ocr_avail);