sh: ecovec: use the CONFIG_MMC_TMIO symbols instead of MFD

[~andy/linux] / arch / sh / boards / mach-ecovec24 / setup.c

diff --git a/arch/sh/boards/mach-ecovec24/setup.c b/arch/sh/boards/mach-ecovec24/setup.c
index 7bdb572ddf9382247986a801b72addb650883e81..baff9ae1a80a803483336ad42acadaad21256f2a 100644 (file)
--- a/arch/sh/boards/mach-ecovec24/setup.c
+++ b/arch/sh/boards/mach-ecovec24/setup.c
@@ -142,6 +142,8 @@ static struct resource sh_eth_resources[] = {
 static struct sh_eth_plat_data sh_eth_plat = {
        .phy = 0x1f, /* SMSC LAN8700 */
        .edmac_endian = EDMAC_LITTLE_ENDIAN,
+       .register_type = SH_ETH_REG_FAST_SH4,
+       .phy_interface = PHY_INTERFACE_MODE_MII,
        .ether_link_active_low = 1
 };
 
@@ -462,7 +464,7 @@ static struct i2c_board_info ts_i2c_clients = {
        .irq            = IRQ0,
 };
 
-#ifdef CONFIG_MFD_SH_MOBILE_SDHI
+#if defined(CONFIG_MMC_TMIO) || defined(CONFIG_MMC_TMIO_MODULE)
 /* SDHI0 */
 static void sdhi0_set_pwr(struct platform_device *pdev, int state)
 {
@@ -878,7 +880,7 @@ static struct platform_device *ecovec_devices[] __initdata = {
        &ceu0_device,
        &ceu1_device,
        &keysc_device,
-#ifdef CONFIG_MFD_SH_MOBILE_SDHI
+#if defined(CONFIG_MMC_TMIO) || defined(CONFIG_MMC_TMIO_MODULE)
        &sdhi0_device,
 #if !defined(CONFIG_MMC_SH_MMCIF)
        &sdhi1_device,
@@ -1160,7 +1162,7 @@ static int __init arch_setup(void)
        gpio_direction_input(GPIO_PTR5);
        gpio_direction_input(GPIO_PTR6);
 
-#ifdef CONFIG_MFD_SH_MOBILE_SDHI
+#if defined(CONFIG_MMC_TMIO) || defined(CONFIG_MMC_TMIO_MODULE)
        /* enable SDHI0 on CN11 (needs DS2.4 set to ON) */
        gpio_request(GPIO_FN_SDHI0CD,  NULL);
        gpio_request(GPIO_FN_SDHI0WP,  NULL);