Part 2 - When dmatest is built as a module...
-After mounting debugfs and loading the module, the /sys/kernel/debug/dmatest
-folder with a file named 'run' nodes will be created. 'run' controls run and
-stop phases of the test.
-
-Note that in this case test will not run on load automatically.
-
Example of usage:
+ % modprobe dmatest channel=dma0chan0 timeout=2000 iterations=1 run=1
+
+...or:
+ % modprobe dmatest
% echo dma0chan0 > /sys/module/dmatest/parameters/channel
% echo 2000 > /sys/module/dmatest/parameters/timeout
% echo 1 > /sys/module/dmatest/parameters/iterations
- % echo 1 > /sys/kernel/debug/dmatest/run
+ % echo 1 > /sys/module/dmatest/parameters/run
+
+...or on the kernel command line:
+
+ dmatest.channel=dma0chan0 dmatest.timeout=2000 dmatest.iterations=1 dmatest.run=1
Hint: available channel list could be extracted by running the following
command:
Note that running a new test will not stop any in progress test.
-The following command should return actual state of the test.
- % cat /sys/kernel/debug/dmatest/run
-
-To wait for test done the user may perform a busy loop that checks the state.
-
- % while [ $(cat /sys/kernel/debug/dmatest/run) = "Y" ]
- > do
- > echo -n "."
- > sleep 1
- > done
- > echo
+The following command returns the state of the test.
+ % cat /sys/module/dmatest/parameters/run
+
+To wait for test completion userpace can poll 'run' until it is false, or use
+the wait parameter. Specifying 'wait=1' when loading the module causes module
+initialization to pause until a test run has completed, while reading
+/sys/module/dmatest/parameters/wait waits for any running test to complete
+before returning. For example, the following scripts wait for 42 tests
+to complete before exiting. Note that if 'iterations' is set to 'infinite' then
+waiting is disabled.
+
+Example:
+ % modprobe dmatest run=1 iterations=42 wait=1
+ % modprobe -r dmatest
+...or:
+ % modprobe dmatest run=1 iterations=42
+ % cat /sys/module/dmatest/parameters/wait
+ % modprobe -r dmatest
Part 3 - When built-in in the kernel...
or status. A test thread also emits a summary line at completion listing the
number of tests executed, number that failed, and a result code.
+Example:
+ % dmesg | tail -n 1
+ dmatest: dma0chan0-copy0: summary 1 test, 0 failures 1000 iops 100000 KB/s (0)
+
The details of a data miscompare error are also emitted, but do not follow the
above format.