6kohm_to_gnd: connected to ground via a 6kOhm resistor,
20kohm_to_gnd: connected to ground via a 20kOhm resistor,
100kohm_to_gnd: connected to ground via an 100kOhm resistor,
+ 500kohm_to_gnd: connected to ground via a 500kOhm resistor,
three_state: left floating.
For a list of available output power down options read
outX_powerdown_mode_available. If Y is not present the
Description:
This attribute is used to read the amount of quadrature error
present in the device at a given time.
+
+What: /sys/.../iio:deviceX/in_accelX_power_mode
+KernelVersion: 3.11
+Contact: linux-iio@vger.kernel.org
+Description:
+ Specifies the chip power mode.
+ low_noise: reduce noise level from ADC,
+ low_power: enable low current consumption.
+ For a list of available output power modes read
+ in_accel_power_mode_available.
+
+What: /sys/bus/iio/devices/iio:deviceX/store_eeprom
+KernelVersion: 3.4.0
+Contact: linux-iio@vger.kernel.org
+Description:
+ Writing '1' stores the current device configuration into
+ on-chip EEPROM. After power-up or chip reset the device will
+ automatically load the saved configuration.